Amplificator RGB

Using Instruction
1) When the load power is over the controller’s max output power, you should use the
amplifier. Amplifier quantity depends is base on the led product’s max loading.
2) four pin connections port (connect power) is the input port, six pin connects is output
port, as the diagram showing, connect the wire base on the printed instruction. V+ is
the anode wire, R, G, B pin port is corresponding R,G,B wire which is from RGB light
bar.
3) Suggest use drawing 3,4 connect way when the led product is too long. This method
can guarantee lighting’s synchronization
4) SIGNAL LIGHT POWER LIGHT
5) DC12VıInput Voltage. Please make sure match the anode and cathode when
connection.
Notice:
1) Before use it, be sure check the RGB light bar or RGB LED Module voltage is suitable
with the amplifier or not.
2) Power supply max load power need to be kept 20% rest.
3) If the led product doesn’t use the same power supply, need to connect cathode of all
the power supply together.
4) Account switch power volume with the Max volume of RGB, and keep 20% volume
remains, use the output wire when the current is over 5A.
5) Connect the wires of the controller and LED fittings according to the instruction